Back - FAQ Home

---

• I've upgraded my version of WES and now my cases do not run properly
• How do I relocalize or customize my case?
• How do I build a local case?
• How do I add archived AWIPS text products to a WES simulation?

• I've upgraded my version of WES and now my cases do not run properly [top]

It is likely that your AWIPS localization was built with a previous version of AWIPS. After every AWIPS build upgrade with WES, you need to create a new localization following the instructions labeled Create a New Localization for Your Local Case [previous version] in the installation instructions.

Additional Helpful Information:

• Customizing AWIPS [Previous Version]
• Using Local Customizations with Non-Local Cases [Previous Version]
• Creating A New Localization for a Non-Local Case [Previous Versions]
• Setting Up A New Case From Scratch [Previous Version]

• How do I relocalize or customize my case? [top]

Localization and customization instructions are available in Sections 8 and 9 of the Install Instructions.

Additional Helpful Information:

• Previous Version of Section 8
• Previous Version of Section 9

• How do I build a local case? [top]

Instructions for archiving and setting up a new case are available in the Archiving and Setting Up a New Case [previous version] section of the Install Instructions.

If you are designing a case to sue with an AvnFPS simulation, then see the instructions on Configuring AvnFPS for a Simulation [previous version].

• How do I add archived AWIPS text products to a WES simulation?[top]

Instructions for archiving and setting up a new case are available in the Adding Archived Text Data to Postgres [previous version] section of the Install Instructions.